The postflight photograph of the Low Tem perature Heat Pipe Package (HEPP) power tray was taken in the SAEF II at KSC after an all up system checkout with interfacing experiments and removal of the tray from the LDEF. An outline of the experiment tray clamp blocks is clearly visible in the light brown stain on the experiment tray flanges. The Low Temperature Heat Pipe Package (HEPP) experiment occupies two 12 inch deep LDEF experiment trays connected with an inter-tray wiring harness. The HEPP Power tray, an end cor ner tray, occupies a location on the space end of the LDEF in tray location H01 and the HEPP Experiment tray, a peripheral tray, is located in the LDEF tray location F12. The power tray (H01) consist of four solar array panels, one nickel-cadmium (NiCd) battery, a Power System Electronics (PSE) unit, protective thermal blankets that line the tray interior and a thirty seven pound baseplate mounted on thermal isolators to provide a thermally stable mounting for the bat tery and the PSE. Thirteen strips of thin film thermal control materials, part of an experiment by NASA GSFC that consist of sixty-five samples located at three different LDEF tray locations (H01, F09 and F12), were attached to the experiment tray flanges with Kapton tape. The experi ment was assembled and mounted in the experiment tray with non-magnetic stainless steel fasten ers. The experiment hardware appears to be intact with no apparent changes other than stains along outer edges of the solar arrays. The light brown stains observed along the upper edges of the solar array mounting plates and around the outer edge of the baseplate in the flight photograph are not apparent in the postflight photo. The atomic oxygen experiment thin film strips appear to be in place with no apparent damage. The Kapton tape appears to be firmly adhered to the tray flanges in all thirteen locations.